CAUTION:
To prevent damage to the storage sled locks, use a #2 Phillips screwdriver to turn the sled locks to lock or unlock
positions.
NOTE:
This is a field replaceable unit (FRU). Removal and installation procedures must be performed only by Dell certified
service technicians.
1
Ensure that you read the
.
2
Follow the procedure listed in
Before working inside your system
.
3
Keep the #2 Phillips screwdriver ready.
4
Remove the bezel assembly.
Steps
1
Turn the sled over with the bottom side of the sled facing up.
2
Align the bezel assembly with the sled front panel and push the assembly into the sled until it is fully seated.
3
Install the screws securing the bezel assembly to the bottom side of the sled.
4
Turn the sled over with the top side of the sled facing up.
5
Install the screws securing the bezel assembly to the top of the sled.
6
Close the drive drawer.
7
Using a #2 Phillips screwdriver, turn the sled locks to unlock position.
8
Align the service caution label and paste the label on top of the drive drawer.
Next steps
1
Install the Mini Enterprise Service Tag (MEST).
2
Follow the procedure listed in
After working inside your system
.
Related links
Removing the bezel assembly
Installing the Mini Enterprise Service Tag
Installing and removing storage sled components
37
