Installing System Components | 183
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
4
Place the upper middle plane holder into the chassis. See Figure 3-40.
5
Replace the screws that secure the middle plane holder to the chassis.
See Figure 3-40.
16
Place the middle plane holder support into the chassis. See Figure 3-39.
6
Replace the screws that secure the middle plane holder support to the
chassis. See Figure 3-39.
7
Place the upper middle plane on the middle plane holder. Make sure
that the two stand-offs on the middle plane holder are inserted through
the slot on the upper middle plane. See Figure 3-38.
8
Replace the screws that secure the upper middle plane to the middle
plane holder. See Figure 3-38.
9
Connect all the cables to the upper middle plane.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
10
Align the locking-tab holes on the cooling-fan bracket to the
corresponding locking tabs on the chassis, and then press down the
cooling-fan bracket into the chassis until secured firmly. See Figure 3-
37.
11
Replace the cooling fans. See "Installing a Cooling Fan" on page 176.
12
Replace the system-board assemblies. See "Installing a System-Board
Assembly" on page 116.
13
Close the system, see "Closing the System" on page 174.
14
Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.
