Dell POWER VAULT 130T LIBRARY 130T, Service Manual, Page: 40 / 96

Required Tools
PowerVault 130T Service Manual
3–4
4473D
Required Tools
The following tools are required for some removal/replace procedures and must be
provided by the customer:
Flashlight
Torx screwdriver
Wire clipper
Customer Replaceable Units
Customer Replaceable Units (CRUs) are designed to be removed/replaced by an
individual with minimal technical experience. Follow all precautions and
instructions.
Table 3–1. CRU Locations and Functions
Units Locations Functions Page #s
DLT drive tray
assembly Left rear of the
library Holds tape drive and its power
supply
3–13
Field Replaceable Units
Field Replaceable Units (FRUs) are to be removed/replaced only by technically
trained service personnel.
Table 3–2. FRU Locations and Functions
Units Locations Functions Page #s
CYC card Part of the
electronics module
(EM) Microprocessor that monitors
and controls all functions of
the 130T library.
3–6
CYO card
(operator panel
assembly) Front of the
library, above the
CAP. Displays library and drive
statuses. Used for configuring
the system, running
diagnostics, and examining
errors.
3–8
DLT Drive Tray
Assembly Left rear of the
library Holds drive assembly for
read/write operations
3–13
Electronics
module Right rear of the
library Houses the power supply,
CYC card, fan assemblies
3–19
Hand/camera
assembly Attaches to the
bearing block on
the Z column Mounts and dismounts
cartridge tapes from storage
cells and tape drives.
3–25