4. Disassembly and Assembly Procedures
S2
4
.1 Disassembly Procedures:
S1
S3
S5
S4
Remove the monitor stand base:
1. Place the monitor on a soft cloth or cushion.
2. Press and hold the stand-release button.
3. Lift the stand up and away from the monitor.
S6
Use one hand to press the rear cover, then wedge
your fingers between the rear cover and the middle
bezel on the corners of the top left side to the right
side of the monitor to release the rear cover.
Use a Philips-head screwdriver to remove four
screws for unlocking mechanisms.
(No.1~4 screw size=M4x10,Torque=12
±0.5
kgfxcm)
Remove the rear cover. Tear off the aluminum foil,
and then disconnect the USB cable and
away from the connector of the interface
board. Use
Function
key cable
a Philips-head screwdriver to remove
one screw for unlocking the USB unit, remove the
USB unit from the hooks.
(No.1 screw size=M3x5, Torque=4
±0.5
kgfxcm)
1
2
4
3
1
U
.
se a Philips-head screwdriver to remove four
screws for unlocking the bracket chassis module
with the panel module
(No.1~4 Screw size= M3x4, Torque=5
±0.5
kgfxcm)
4
1
2
3
Disconnect the panel power cable to the connector of
the panel module. Then disconnect the other cables
as the below picture shown.
Necessary repair and test equipment:
1. Philips-head screwdriver
2. Hex-head screwdriver
