22
| Setting Up the Monitor
Setting Up the Monitor
Attaching the Stand
NOTE:
The stand is detached from monitor when it is shipped from the factory.
NOTE:
The procedure below is applicable for the default stand. If you purchased
any other stand, see the documentation shipped with the stand to set it up.
CAUTION: Place monitor of a flat, clean, and soft surface to avoid scratching the
display panel.
To attach the monitor stand:
1
Place the monitor on a flat surface.
2
Insert the two tabs on the upper part of the stand in the slots on the back of
the monitor.
3
Press the stand down till it snaps into place.
Connecting Your Monitor
WARNING: Before you begin any of the procedures in this section, follow the
Safety Instructions
.
To connect your monitor to the computer:
1
Turn off your computer and disconnect the power cable.
2
Connect the mDP-DP/HDMI/USB cable from your monitor to
the computer.