Steps
1. In reverse sequential order (7>6>5>4>3>2>1) loosen the seven captive screws (M2x2) that secure the heat sink to the
system board.
2. Lift the heat sink from the system board.
Installing the heat sink (discrete graphics)
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
If either the system board or the heat sink is replaced, use the thermal grease provided in the kit to ensure that
thermal conductivity is achieved.
The following image(s) indicate the location of the heat sink (discrete graphics) and provides a visual representation of the
installation procedure.
Steps
1. Place the heat sink on the system board.
46
Removing and installing components
