Installing the M.2 2280 solid-state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
Slot 2 can only support M.2 Gen 4 PCIe x4 NVMe solid-state drive. You can refer the below procedure to install the
M.2 2280 solid-state drive in both SLOT 1 and SLOT 2.
The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Remove the solid-state drive holder from the system board if required.
2. Align the notch on the solid-state drive with the tab on the solid-state drive slot.
3. Slide the M.2 2280 solid-state drive into the solid-state drive slot on the system board.
4. Replace the screw (M2x4) that secures the M.2 2280 solid-state drive to the system board.
Next steps
1. Install the
.
2. Install the
3. Install the
.
After working inside your computer
.
Removing the M.2 2230 solid-state drive
Prerequisites
Before working inside your computer
.
2. Remove the
3. Remove the
.
4. Remove the
.
Removing and installing components
29
Summary of Contents for P104F
