5.
Ground yourself and install the new memory module:
a.
Align the notch in the module edge connector with the tab in the connector slot.
b.
Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove
the module and reinstall it.
DIMM B
1.
Follow the procedures in
Before You Begin
.
2.
Turn the computer over, loosen the captive screw in the memory module cover, and then remove the cover.
3.
If you are replacing a memory module, ground yourself and remove the existing module:
a.
Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
b.
Remove the module from the connector.
NOTICE:
Insert memory modules at a 45-degree angle to avoid damaging the connector.
NOTE:
If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
NOTICE:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you install a
module in the connector labeled "DIMM B." Insert memory modules at a 45- degree angle to avoid damaging the connector.
1
memory module cover
2
captive screw
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the memory-module securing clips.