Steps
1. Using the alignment posts and rubber grommets, place the speakers on the slots of the palm-rest and keyboard assembly.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the speaker cable to the palm-rest and keyboard assembly.
4. Connect the speaker cable to the system board.
5. Place the antenna cables over the speaker cable and adhere the tape that secures the antenna cables to the palm-rest and
keyboard assembly.
Next steps
1. Install the
.
2. Install the
.
3. Install the
.
After working inside your computer
.
Heat sink
Removing the heat sink
Prerequisites
Before working inside your computer
.
2. Remove the
.
About this task
CAUTION:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils
in your skin can reduce the heat transfer capability of the thermal grease.
WARNING:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
Removing and installing components
31
