Replacing the speakers
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your computer
computer, follow the instructions in
. For more safety best practices, see the Regulatory
Compliance home page at
www.dell.com/regulatory_compliance
.
Procedure
NOTE: The rubber grommets may get pushed out while replacing the
speaker. Ensure that the rubber grommets are in their position after
placing the speaker on the palm-rest assembly.
1
Using the alignment posts, align and place the speakers on the palm-rest
assembly.
2
Replace the rubber grommets if they are pushed up while replacing the
speaker.
3
Route the speaker cable through the routing guides on the palm-rest
assembly.
4
Adhere the pieces of tape that secure the speaker cable to the palm-rest
assembly.
5
Connect the speaker cable to the system board.
Post-requisites
1
.
2
.
45
Summary of Contents for Inspiron 13 5000
