Dell EqualLogic Configuration Guide v11.3
62
F.1
Enabling the PortFast Option to Configure STP Edge Ports
To configure STP edge ports on Cisco IOS-based switches, the Portfast option must be set on the
desired port(s).
The following example shows how to enable PortFast on Gigabit Ethernet interface 0/1 on switch 1:
Switch> enable
Switch# configigure terminal
Switch(config)# interface gi1/0/1
Switch(config-if)# spanning-tree portfast
Switch(config-if)# exit
Switch(config)# exit
Switch# copy running-config startup-config
To view or confirm Port Fast status on a port, use the following command.
Switch# show spanning-tree interface gigabitethernet0/1
Note: Use the spanning-tree portfast default global configuration command to globally enable the
PortFast feature on all non-trunking ports.
This example shows how to globally enable PortFast by default on all access ports:
Switch# config terminal
Switch(config)# spanning-tree portfast default
Switch(config)# end
Switch# copy running-config startup-config
For additional information on understanding and configuring Spanning-Tree Protocol on Cisco Catalyst
switches, see:
http://www.cisco.com/en/US/tech/tk389/tk621/technologies_configuration_example09186a00800946
7c.shtml
F.2
Configuring Flow Control
This section describes how to configure Flow Control on Cisco Catalyst 3750 and 2970 switches. You
must enable Flow Control on each switch port that handles iSCSI traffic.
Note:
Cisco Catalyst switch ports are capable of receiving, but not sending, pause frames.
Summary of Contents for EqualLogic PS4000
Page 1: ...Dell EqualLogic Configuration Guide Dell EqualLogic Storage Infrastructure and Solutions ...
Page 11: ...Dell EqualLogic Configuration Guide v11 3 6 Figure 1 Partially Connected Controller Failover ...
Page 44: ...Dell EqualLogic Configuration Guide v11 3 39 Figure 14 Mixed Speed Redundant SAN ...
