Dell EMC VxFlex Ready Node 14G, Hardware Installation Manual

Page: 67 / 86

Figure 25 B13 sliding rail assembly - 2U systems
1. B13 sliding rail (2)
2. velcro strap (2)
3. screw (4)
4. washer (4)
Install the rails
The rails are labeled left and right, and cannot be interchanged. The front side of each
rail is labeled Left Front or Right Front when the rail faces the cabinet front.
Procedure
1. Determine where to mount the system, and mark the location at the front and
back of the cabinet.
Note
Install the left rail assembly first.
2. Fully extend the rear sliding bracket of the rail.
3. Position the rail end piece labeled Left Front facing inward and orient the rear
end piece to align with the holes on the rear cabinet flanges.
4. Push the rail straight toward the rear of the rack until the latch locks in place.
2U1N Configuration Equipment Installation
Install the rails 67