IEEE standards
The Edge 510 LTE complies with the following IEEE standards:
●
802.1ab—LLDP
●
802.1ax—Layer 2
●
802.1d, 802.1w, 802.1s, 802.1x—Mgmt/Security; 802.3x—Layer 2
Agency compliance
The Edge 510 LTE complies with the following safety and agency requirements:
USA Federal Communications Commission statement
CAUTION:
The use of external signal amplifiers in-line with the transceiver antennas is strictly prohibited.
CAUTION:
Use only the antenna(s) which have been approved by the applicant. Non-approved antenna(s) may
produce unwanted spurious or excessive RF transmitting power which may lead to a violation of FCC/IC limits
and is prohibited.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC caution
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Radiation exposure statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
Industry Canada Statement
CAUTION:
The use of external signal amplifiers in-line with the transceiver antennas is strictly prohibited.
20
Specifications
