Checking system status
Before you begin
You should still be in your HyperTerminal session.
Procedure
To view the system state:
1. Enter the following command to verify the system state:
# /nas/bin/nas_checkup
Example:
# /nas/bin/nas_checkup
]# /nas/bin/nas_checkup
Check Version:
<NAS_version>
Check Command:
/nas/bin/nas_checkup
Check Log
:
/nas/log/checkup-run.100128-181007.log
-------------------------------------Checks-------------------------------------
Control Station: Checking if file system usage is under
limit.............. Pass
Control Station: Checking if NAS Storage API is installed
correctly........ Pass
Control Station: Checking if NBS clients are
started....................... Pass
Control Station: Checking if NBS configuration
exists...................... Pass
Control Station: Checking if NBS devices are
accessible.................... Pass
Control Station: Checking if NBS service is
started........................ Pass
Storage System : Checking for unsupported storage
profile.................. Pass
Storage System : Checking if Fibre Channel zone checker is set
up..........
N/A
Storage System : Checking if Fibre Channel zoning is
OK....................
N/A
Storage System : Checking if proxy arp is
setup............................ Pass
Storage System : Checking SPA SPB
communication............................ Pass
--------------------------------------------------------------------------------
If the output of the nas_checkup command indicates any problems, correct the problems
and re-do the command before continuing.
18
Replacing a Standby Power Supply
Checking system status
