Dell DR4000 Restore Manager, Owner'S Manual, Page: 82 / 156

82
Installing System Components
Removing an Expansion Card
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 60.
3 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 62.
4 Disconnect all cables from the card.
5
Open the expansion-card latch. See Figure 3-14.
6
Grasp the expansion card by its edges, and carefully remove it from the
expansion-card connector.
7
If you are removing the card permanently, install a metal filler bracket over
the empty expansion slot opening and close the expansion-card latch.
NOTE:
You must install a filler bracket over an empty expansion slot to
maintain Federal Communications Commission (FCC) certification of the
system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
8 Close the system. See "Closing the System" on page 61.
9 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Table 3-2. Expansion-Card Installation Priority for Riser 1
Card
Priority
Card Type
Slot
Priority Max
Allowed 25 W
Card
1 PERC H800 3 1 Y
2 8 GB NVRAM card 2 1 Y
3 10 GB NIC 1 1 Y
4 All other NICs 1 1 N
book.book Page 82 Friday, January 6, 2012 2:11 PM