Dell DR4000 Restore Manager, Owner'S Manual, Page: 147 / 156

Jumpers and Connectors
147
The existing passwords are not disabled (erased) until the system boots
with the password jumper plug in the "disabled" position. However, before
you assign a new system and/or setup password, you must return the
jumper plug to the enabled position.
NOTE:
If you assign a new system and/or setup password with the jumper
plug still in the "disabled" position, the system disables the new password(s)
the next time it boots.
6
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
7
Open the system. See "Opening the System" on page 60.
8
Move the password jumper back to the enabled position to restore the
password function. See Table 6-1.
9 Close the system. See "Closing the System" on page 61.
10 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
11 Assign a new system and/or setup password.
To assign a new password using the System Setup program, see "System
and Setup Password Features" on page 51.
book.book Page 147 Friday, January 6, 2012 2:11 PM