Removing and Replacing Parts: Dell™ Dimension™ XPS T
xxx
and T
xxx
r Systems
Reference
•
•
•
SECC2 Package and Heat Sink Assembly
•
•
Overview
Unless otherwise noted, each of the following procedures assumes:
l
l
You have performed the steps listed in the Caution in
.
l
.
l
You can replace or reinstall a part by performing the removal procedure in reverse order.
Precautionary Measures
Before you remove or replace parts in the system, read the following caution for your personal safety and to prevent damage to the system from
ESD.
After you remove or replace parts in the system, observe the following notice to prevent damage to the system.
NOTICE: Make sure all other system cables are connected before connecting the computer to its electrical outlet.
Recommended Tools
l
Small flat-blade screwdriver
l
Wide flat-blade screwdriver
l
#1 and #2 Phillips-head screwdrivers
l
1/4-inch nut driver
l
Tweezers or long-nose pliers
l
Wrist grounding strap
Cover and Support Beam
CAUTION FOR YOUR PERSONAL SAFETY AND PROTECTION OF THE EQUIPMENT:
Before you start to work on the system, perform the following steps in the sequence listed:
1. Turn off your computer and all devices.
2. Ground yourself by touching an unpainted metal surface at the back of the computer before touching
anything inside your computer.
While you work, periodically touch an unpainted metal surface on the computer to dissipate any static
electricity that might harm internal components.
3. Disconnect any devices connected to the computer, including the monitor, from their electrical outlets to
reduce the potential for personal injury or shock. Also, disconnect any telephone or telecommunication
lines from the computer.
4. Disconnect the power cable to your computer, and then press the
board.
Summary of Contents for Dimension XPS T R Series
Page 45: ...Back to Contents Page ...
