Dell 5110cn - Color Laser Printer, Service Manual

Page: 393 / 642

3 - 143
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP5.17 INNER DUPLEX ASSEMBLY (PL5.2.1), DUPLEX HINGE LINK SPRING
(PL5.1.6), DUPULEX HINGE LINK (PL5.1.7)
[Replacement]
1) Holding INNER DUPLEX ASSEMBLY, insert SHAFT PIVOT R and SHAFT PIVOT L up to
the half of the respective shafts.
2) Put the hole in DUPLEX HINGE LINK over the boss into the right side of the printer.
3) Attach DUPLEX HINGE LINK SPRING to DUPLEX HINGE LINK on the right side of the
printer.
4) Pass the harness through the harness guide located in the clearance between the right side of
the printer and the bottom plate.
5) Attach GUIDE HARNESS F to the right side of the printer using two screws (silver, tap,
10mm).
6) Pass the harness through GUIDE HARNESS F to the right side of the printer.
7) Attach the connector (P/J36, P/J52) to MACHINE CONTROL UNIT (MCU).
8) Pass the harness through GUIDE HARNESS R to the right side of the printer.
9) Attach CLAMP GUIDE HARNESS to GUIDE HARNESS R on the right side of the printer.
10) Attach the connector (P/J162) to LOW VOLTAGE POWER SUPPLY (LVPS).
11) Attach the ground wire to the right side of the bottom plate using a screw (silver, provided
with external tooth washer, 5 mm).
12) Attach OUTER DUPLEX ASSEMBLY. (RRP5.18)
13) Attach MULTIPURPOSE FEEDER (MPF) COVER. (RRP1.10)
14) Attach MULTIPURPOSE FEEDER (MPF) TRAY. (RRP1.9)
15) Attach LEFT SIDE COVER. (RRP1.12)
16) Attach RIGHT SIDE COVER. (RRP1.7)
17) Attach LEFT FRONT COVER. (RRP1.11)
18) Attach RIGHT FRONT COVER. (RRP1.8)
19) Attach FRONT COVER. (RRP1.3)
20) Attach TOP COVER FRAME. (RRP1.1)