Dell EMC PowerVault ME484, Owner'S Manual

Page: 39 / 152

Fault LED (Amber) Status/description*
Any links down: On Drive link (PHY lane) down
On Fault (leftover/failed/locked-out)
Off Available
Off Storage system: Initializing
Off Storage system: Fault-tolerant
Off Storage system: Degraded (non-critical)
Blinking: 3s on/1s off Storage system: Degraded (critical)
Off Storage system: Quarantined
Blinking: 3s on/1s off Storage system: Offline (dequarantined)
Off Storage system: Reconstruction
Off Processing I/O (whether from host or internal activity)
*If multiple conditions occur simultaneously, the LED state will behave as indicated by the condition listed earliest in the table, as rows are
read from top to bottom.
Each DDIC has a single Drive Fault LED. A disk drive fault is indicated if the Drive Fault LED is lit amber. In the event of a disk failure, follow
the procedure in
Replacing a DDIC .
IOM LEDs
NOTE: IOM CRUs are common to the 2U and 5U84 enclosures.
• For information about controller module LEDs see 12 Gb/s controller module LEDs .
• For information about expansion module LEDs see Expansion module LEDs .
Troubleshooting 2U enclosures
The following sections describe common problems that can occur with your enclosure system, and some possible solutions. For all of the
problems listed in
Table 20. 2U alarm conditions , the Module Fault LED on the Ops panel will light amber to indicate a fault. All alarms also
report using SES.
Table 20. 2U alarm conditions
Status Severity Alarm
PCM alert - loss of DC power from a single PCM Fault – loss of redundancy S1
PCM fan fail Fault – loss of redundancy S1
SBB module detected PCM fault Fault S1
PCM removed Configuration error None
Enclosure configuration error (VPD) Fault – critical S1
Low warning temperature alert Warning S1
High warning temperature alert Warning S1
Troubleshooting and problem solving 39