2. Insert the copper ends into the mating connectors and tighten the captive screws at the top of the mating connector using a Phillips
#2 screwdriver.
NOTE:
To protect the power supply from electrostatic discharge, the captive screws must be covered with the
rubber cap before inserting the mating connector into the power supply.
3. Rotate the rubber cap clockwise to fix it over the captive screws.
4. Insert the mating connector into the power supply.
Cooling fan
Removing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
Steps
Holding the orange and black edges on the fan module, lift the cooling fan module vertically to disconnect from the connector on the fan
backplane.
Figure 47. Cooling fan removal
Next steps
Installing a cooling fan
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system.
Steps
1. Align and place the fan module connector horizontally with the connector on the system board.
Installing and removing system components
73
