Figure 82. Installing the M.2 SSD module
Next steps
1. Install the BOSS card. Installing the BOSS is similar to
installing expansion card into the expansion card riser
2. Follow the procedure listed in the
After working inside your system
.
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the
same or equivalent type That is recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions. See the Safety instructions. that came with your system for more information.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Before working inside your system
.
3. If applicable, disconnect the power or data cables from the expansion cards.
4.
Remove the expansion card risers
.
Steps
1. To remove the battery:
a) Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
104
Installing and removing system components
