Dell EMC E02B, Installation And Service Manual, Page: 89 / 108

a Drives
b Drive backplane
Steps
1 Locate the system battery on the system.
2 To remove the battery:
a Push the battery holder slightly away.
NOTE: Ensure that you do not push the battery holder more that 3.2 millimeters or you might risk damaging the part.
b Push the battery toward the positive side of the battery till the battery disengages from the connector.
c Lift the battery away from the system.
Figure 46. Removing the system battery
3 To install a new system battery:
a Push the battery holder slightly away.
NOTE: Ensure that you do not push the battery holder more that 3.2 millimeters or you might risk damaging the part.
b Hold the battery with the "+" sign facing the positive side of the battery connector.
c Insert the battery down into the connector and push the positive side of the battery until the battery snaps into place.
Figure 47. Installing the system battery
Next steps
1 Install the following:
a Drive backplane
b Air shroud
c Drives
2 Follow the procedure listed in After working inside your system .
3 Enter the System Setup to confirm that the battery is operating properly.
Installing and removing system components 89