Delabie SPORTING 2, Manual

Page: 14 / 24

13
OPERATION
• Press the push-button starter firmly to open the valve.
• Automatic shut-off after ~30 seconds (+5/-10 according to the European standard EN 816).
INSTALLATION
• In order to capture all of the spray, install the shower tray 10cm from the wall: we recommend recessed
shower trays or sloping gutters. If a small, raised shower tray is installed, the shower nozzle
can be replaced with a grid (Ref. GR) to concentrate the jet.
• When the push-button starter is released, a trickle of water will exit below the push-button.
This primes the hydraulic timing and activates the shower valve at the same time. Once the push-button
is released, the trickle of water will stop.
THE INSTALLER MUST:
• ENSURE THAT THE CONNECTION BETWEEN PANEL AND THE WATER INLET IS WATERPROOF
ON THE RECESSED INLET VERSION;
• CHECK THE INTEGRITY OF THIS CONNECTION AT LEAST ONCE A YEAR AND AS OFTEN AS
NECESSARY.
If this advice is not followed, water may leak into the wall. DELABIE cannot be held responsible
for any ingress.
FOR FURTHER INFORMATION PLEASE CALL DELABIE TECHNICAL SUPPORT
UK: 01491 821821. ALL OTHER MARKETS: +33 (0)3 22 60 22 74.
REMEMBER
•
Our valves must be installed by professional installers
in accordance with current regulations
and recommendations in your country, and the specifications of the fluid engineer.
•
Sizing the pipes correctly
will avoid problems of flow rate, pressure loss and water hammer
(see calculation table in our brochure and online at www.delabie.com).
• Protect the installation with filters, water hammer absorbers and pressure reducers to reduce
the frequency of maintenance (recommended pressure from 1 to 5 bar maximum).
•
Install stopcocks
close to the tap to facilitate maintenance.
• The pipework, filters, non-return valves, stopcocks, bib taps, cartridge and all sanitary fittings
should be checked at least once a year, and more frequently if necessary.
EN