4
5
Aquaclipse
Installation & Operations Manual
Aquaclipse
Installation & Operations Manual
2B. Electrical
Simply plug the ZO-400 into a properly rated receptacle, installed to
applicable electrical codes. The receptacle must be protected by a
GFCI or RCD.
SECTION 3 Controls
3A. Power
The DEL Ozone Aquaclipse has a power switch on the front panel
for turning the system on and off. The light next to the switch will
illuminate when the system is powered on.
3A-1 Indicator lights
1. System Power – The green light in between the timer and the
switch will light up when the switch is in the on position and the
system has power.
2. Ozone Modules – To view the Ozone Module lights, open the
Acess Panel as described in Section 5A. Turn power on briefly to
view lights.
DO NOT touch the ZO-400 or the internal components while unit is
operational
.
3B. Timer
The ZO-400 is equipped with a built-in timer to control the operation
of the ozone generator. The timer has 96 moveable tabs, each
representing a 15 minute period of operation. Push the tabs
INWARD to turn ON the ozonator, and OUTWARD to turn it OFF.
To use the timer, remove the plastic cover and depress enough
consecutive tabs on the dial for the desired operating time. For
example, four consecutive tabs need to be pushed in for one
hour of operation (
Figure 1). Plug in the ZO-400 and turn the
main power switch on. Rotate the timer clockwise. When the
first depressed tab reaches the pointer in the center of the timer,
the ozonator will turn on. The ozonator will turn off again upon
reaching the first undepressed tab, or when the main power switch
is turned off.
The timer will continue to run as long as the ZO-400 is plugged
in, even if the power switch is off. You can set the time of day by
rotating the dial clockwise until the correct time is lined up at the
pointer.
SECTION 4 Water Treatment
The ZO-400 Aquaclipse can purify water in atmospheric tanks,
emergency storage, spas, bathtubs, fountains, and wading pools
up to 20 feet deep. It is specifically designed to purify drinking water
from well sources or city water supplies, removing undesirable
tastes, odors and colors caused by iron, copper, manganese,
chlorine and organics. The Aquaclipse is especially good at
removing the sulfur smell from well water.
DO NOT use water from a source that is questionable such as
stagnant pool water, creeks, ponds, streams, urinary tracts or the
like.
To treat water, place the dispersion stone into the water container
as shown in Figure 1 and set the timer to make the unit run for
the amount of time desired (recommended 24 hr/day operation).
Running the unit less than 24 hours per day may work for your
set-up, but running the unit for longer will not hurt the water or the
system.
When used in conjunction with a particulate filter, ozone will also
remove excess minerals including iron, manganese, and lead, as
well as radon and sulfur gases. It is recommended you check your
filters about 1 month after installation of ozone equipment to gage
rate of clogging.
POWER
SWITCH
FUSE
POWER LIGHT
ACCESS PANEL
SCREWS
