20
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST
Snow Blower
Rev Jan 2016
Check & Replacing the Transmission Drive Belt
If belt needs to be changed or altered for any
reason, the belt is located in the front of the snow
blower behind the discharge chute and in front of
the wheels.
1. Remove the cover that is protecting the snow
blower’s belts. Remove the screws and simply
lift up the cover.
2. Remove the black belt and replace with a new
belt.
3. Attach the cover and all hardware as they
IMPORTANT! The snow blower belts are adjusted to
ensure the augers stop turning within 5 seconds of
releasing the augers/impeller control lever. If you are
making any belt adjustments whatsoever, for your
safety and the safety of others around you, you must
ensure the belts are re-adjusted to achieve this design
Check & Replacing the Augers/Impeller Belt
There are two located in the front of the snow
blower behind the discharge chute and in front of
the wheels.
1. Remove the cover that is protecting the Snow
Beast’s belts. Remove the screws and simply
lift up the cover.
2. Remove the two belts and replace with new
belt or belts depending on the belt’s condition.
3. Attach the cover and all parts as they were
when taken off.
NOTE: Always change both belts at the same
time. Changing only one belt can lead to
performance issues.
Also check for correct belt tension after changing
Service Adjustments
