21
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST
Snow Blower
Rev Jan 2016
Adjusting Discharge Deflector
The discharge chute is preset at the factory, but
may require adjustment over time or during
maintenance.
For adjustments, follow the procedure below:
1. Loosen the two nuts at the chute cable mount
on the discharge chute.
2. To make the chute open more, adjust nuts so
the cable end moves closer to the discharge
deflector (upward).
3. To make the chute close more, adjust nuts so
the cable end moves further from the
Service Adjustments
Changing Friction Wheel
If the friction wheel needs to be replaced for any
reason:
1. Remove the two bolts to remove the cover
underneath the control panel between the
wheels.
2. Remove the bolt and nut in the hexagonal
shaft carrying the friction wheel
3. With the bolt and locking nut removed, the
shaft can be removed with the rubber friction
wheel assembly.
4. Replace the friction wheel and reassemble in
reverse order.
5. Resetting the neutral position may be
necessary.
Replacement friction wheel rubber is available for
Replacing Headlight Bulb
1. Push the headlight case up from the
bottom, then gently lift the headlight out.
2. Twist the black round wire harness counter-
clockwise until the bulb is unlocked at the
spot.
3. Replace the bulb and lock the headlight back
into place the same way it was taken out.
Replacement bulbs are available for purchase
