-6-
143351 - 69/7200 Series (12-May-2017)
Maintenance
GREASING
1. Use only a hand-held grease gun for all
greasing.
2. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt.
3. Replace and repair broken fittings
immediately.
4. If fittings will not take grease, remove and
clean thoroughly. Also clean lubricant
passageway. Replace fitting if necessary.
5. Inject grease until you see grease being
expelled from the pin or bushing areas.
Tilt Bell Plate
Tilt Ring
(Typical both sides)
Blade Pivot Pin
Tilt Cylinder Pins
LUBE AFTER EVERY 8 HRS.
MAINTENANCE SAFETY
1. Review the Operator’s Manual and all safety
items before working with, maintaining or
operating the machine.
2. Lower machine to ground, stop the tractor
engine, place all controls in neutral, set
park brake and remove ignition key before
servicing, adjusting or repairing.
3. Clear the area of bystanders, especially
children when carrying out any maintenance
and repairs or making adjustments.
4. Place safety stands or large blocks under
the frame before removing tires or working
beneath the machine.
5. Be careful when working around or
maintaining a high-pressure hydraulic system.
Wear proper eye and hand protection when
searching for a high pressure hydraulic leak.
Use a piece of wood or cardboard as a
backstop when searching for a pin hole leak
in a hose or a fitting.
6. Always relieve pressure before disconnecting
or working on hydraulic system.
Lift Cylinder Pins
Angle Cylinder Pins
Main/Pivot Pins
Side Bracket Pins
(Both sides)
(Both sides)
(Both sides)
(Both sides)
Please note:
The frame assemblies for your particular fit-up
may differ significantly from those shown in the diagram,
however, the basic grease points should be similar.
Items to Grease
Qty.
Angle Cylinder Pins
2 per cylinder
Lift Cylinder Pins
2 per cylinder
Tilt Cylinder Pins
2 per cylinder
Blade Pivot Pin
1 on left side
Tilt Ring
2 per side
Tilt Bell Plate
1 per side
Side Bracket Pins
1 per side
Main Pivot Pins
1 per side
(7200)
(7200)
(7200)