Page 6
Operation
2
Initial use
Clean the appliance parts before initial use.
Use the appliance upright on a balanced,
flat, clean, dry and non-skid surface.
Do not use the appliance continuously for
more than 10 seconds. Turn off the device
when used for more than 10 seconds and
wait for 1 min. before operating again.
Blending and chopping with the blending
shaft
1. Insert blending shaft (1), by aligning (
ź
)
symbol on motor unit (4) with ( ) symbol
and turning clockwise. Make sure (
ź
)
symbol is aligned with ( ) symbol. Fit it into
its place, do not apply too much force.
2. Put processed ingredients (in small
pieces) in measuring container or a
container that you will use.
3. Immerse blending shaft (1) into the
container.
4. Plug in the appliance.
5. Run the appliance by pressing operation
button (3).
WARNING:
Do not run the
appliance continuously for more
than 10 seconds at a time in
order to prevent overheating.
After running the appliance for 10
seconds, allow for it to cool down
for 1 minute before using it again.
Turn speed adjustment button (2)
to gradually increase speed.
Start mixing in low speed while
mixing ingredients. Ingredients
may be spattered when you start
with high speed.
You can get better results if you
make circular movements with
the appliance during processing.
6. Release the operation switch when the
operation is finished. Unplug the appliance
and wait for it to stop completely.
7. Turn blending shaft (1) counterclockwise
and remove from motor unit (4) when it is
aligned with ( ) symbol.
WARNING:
Never touch the blades with your
bare hands.
Do not chop extremely hard
items such as coffee beans, ice
cubes, nutmeg, grains or bones.
Remove stalks from herbs, shells
from nuts and bones, tendons
and gristle from meat.
Cut the food in small pieces.
Do not use the appliance
continuously for more than 10
seconds.
To achieve the best results press
the operation button (1)
intermittently.
Attachment Ingredients Operation
time
Blender leg
150g carrot
(cut-into
1.5cm cubes)
and 300ml
water
10 seconds
Maximum quantities and processing time
Refer to the table for processing time and
maximum quantities.
