•
The hob should be installed in a ventilated cupboard fitted with a sturdy work-top and
must be secured using the fixing brackets provided.
•
Place the oven on the floor in front of the aperture and make the electrical connection
before installing. This will ensure enough cable length for subsequent servicing.
•
Lift off the top trim and unscrew the bottom trim. This will expose the fixing holes.
•
Secure the oven to the cabinet using suitable screws. (Fasteners are not provided.)
•
Replace the top and bottom trims.
“This appliance must be earthed and the manufacturer and the seller do
not accept responsibility for any damage due to incorrect installation or
electrical connection.”
ELECTRICAL INSTALLATION
Earth leakage
This appliance should not be connected through an earth leakage system.
Refer to S.A.B.S. 0147.
Connection to the power supply
must be carried out by a licensed electrician, who will
ensure that the oven is correctly connected and safely earthed. The rated current is printed
on the serial number label attached to the oven bottom trim.
The appliance must be connected to the mains through a double pole isolating switch
which has a minimum clearance between the contacts of 3 mm. in both poles.
A means for disconnection must be provided in the fixed wiring.
Hob to oven connection
—Two 6 pin electrical plugs are used. (Refer to label on oven)
SAFETY ADVICE
•
Only use the appliance for preparing food.
•
Always keep children away from the appliance when it is in use.
•
Do not leave hot fat or oil unattended. If overheating occurs, these could catch fire.
•
Switch off the power at the mains in the event of a fault or when cleaning the
appliance.
•
Do not store flammable items in the oven. If the oven is inadvertently switched on,
these could catch fire.
•
Never cover the bottom oven element with aluminium foil. Cooking times will be
affected and the oven enamel could be damaged.
•
Avoid spilling fruit juice, particularly citrus, on the appliance as it could damage the
enamel.
•
Always keep the oven door gasket clean as this will enable the door to seal properly.
