Page 7
Appropriate installation location
•
Place the machine on a rigid floor that has
sufficient load carrying capacity.
•
Choose a well ventilated dry location out
of direct sunlight.
•
Do not place the machine on the power
cable.
•
Do not install the machine at places where
the temperature may fall below 0ºC.
•
Place the machine at least 10 mm away
from the edges of other furniture.
•
Hot and cold water taps should be located
within 1 metre of the inlet valves.
Warning:
Do not place the machine
on a rug or carpeted floor as this may
restrict ventilation openings at the
bottom of the machine.
Warning: Do not use old or used water
inlet hoses on the new machine It may
cause stains on your laundry.
Before moving the machine, take note of
figure A
on how to carry the machine.
Figure A
•
Connect the water inlet pipe (with the
metallic filter) on to the tap.
•
Fasten the other end of the water inlet
hose onto the machines water inlet valve.
(with rubber seal ring inside).
Installation of water inlet pipe
Push down slide
jacket to expose
the small ball and
enable separation
of connector
socket from
speedy connector.
Small ball
Installation of water inlet hose
Note: When tightening the
clamping nut, do so evenly and do
not use force or twist the water inlet
valve as the water inlet valve joint
may break.
