
Page 8
The door
x
Open the door by pulling on the handle
x
Opening the door during the drying cycle will
automatically stop the dryer operation.
x
Closing the door will allow the machine to
complete the drying cycle.
x
To close the door, push until a click is heard.
Adding more laundry
x
This only makes sense if the additional laundry is
added near the beginning of a programme.
Otherwise the load would comprise semi-dry and
damp laundry.
x
Press the
Start/Pause
button.
x
Open the door and place the additional laundry in
the drum.
x
Press the
Start/Pause
button.
Child-proof lock
To prevent accidental operation of the dryer, the
controls may be locked during operation.
The loading door and all keys except the
“On/Off”
key
on the panel are deactivated when the child-proof
lock is active.
In order to activate the childproof lock, press the
“Start/Pause”
and
“Low temperature”
buttons
simultaneously for 3 seconds.
To start a new programme after the programme is
over or to interrupt the programme, the childproof lock
should be deactivated. To deactivate the childproof
lock, press the “Start/Pause” and “Low temperature”
buttons simultaneously for 3 seconds.
One of the LEDs on the programme follow-up
indicator starts flashing when the child-proof lock is
activated. The Child-proof lock is deactivated when
the machine is restarted by pressing the
On/ Off
button.
Note. Activating the child lock, does not lock the
door.
Caution:
The inside of
the drum is hot. Avoid
contact to prevent burns.
Filter cleaning
A warning LED will light up as a reminder to clean the
filter after the programme has completed. If the filter
cleaning warning LED lights up continuously, please
refer to, “Troubleshooting”.
Starting the Programme
1.
Press “Start/Pause” button to start the programme.
2.
The “Start/Pause” button will light up to indicate
that the programme has started.
Timer follow-up indicator
One of the lamps is on whilst the programme runs
and shows the approximate remaining time.
LEDs on the timer follow-up indicator will also flash
when the child-proof lock is activated.
If more than one LED lights up or flashes
concurrently, it means there is a malfunction or a
failure (please see, Troubleshooting).
Changing the programme
x
Press the Start/Pause button to pause the
programme.
x
Rotate the programming knob to the desired time.
x
Press the Start/Pause button to start the
programme from the updated time.
Adding/removing laundry in standby mode in
order to add or take out laundry after the start-up
of the programme;
1.
Press the “Start/Pause” button
to switch the machine to “Pause” mode. Drying
process will stop.
2.
Open the door whilst the machine is paused and
close it again after adding or taking out laundry.
3.
Press “Start/Pause” button to start the programme
again.
Any laundry added after the drying process was
started may cause the already dried clothes in the
machine intermingle with wet clothes and the result
will be wet laundry after the drying process is over.
Laundry may be added or taken out as much as
desired during a drying process, but as this process
will interrupt drying continuously, it will extend the
programme duration and increase energy
consumption. Thus it is recommended to add laundry
before the drying programme has started.
Ending the programme
x
Hold the Start/Pause button for 3 seconds.
x
The programme is now cancelled.
x
Please switch the machine off.