Page 10
Technical specifications
9
Drying method
Vented
Dimensions
Height
850mm
Width
600mm
Depth
530mm
Weight, unpacked
+- 30kg (approximately).
Capacity (max)
5kg
Voltage
230V.50Hz
Heater
1 x 1900 W
Motor
85W
Rated power output
See type label (located
on rear of machine)
Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents
suitable for stainless steel. Never use
steel wool or wire wool.
Warning:
Never use sponge or scrub
materials. These will damage the painted
and plastic surfaces.
Do not use benzene or
other solvents to clean
any part of the machine.
Energy saving
8
Things to be done for energy saving:
x
Do not overload the machine. We recommend
loading the drum to the halfway mark.
x
Spin your laundry at the highest speed possible
when washing laundry. Thus, the drying time is
shortened and energy consumption is decreased.
x
Pay attention to dry same types of laundry
together.
x
Follow the instructions in the user manual for
programme selection.
x
Make sure that sufficient clearance is provided at
the front and rear side of the dryer for air
circulation. Do not block the grill.
x
Do not open the door of the machine during drying
unless necessary. If you must open the door, pay
attention not to keep it open for a long time.
x
Do not add new (wet) laundry during drying.
x
Lint and fibres released from the laundry to the air
during the drying cycle are collected in the “Lint
Filter”. Make sure that you clean the filters before
or after each load.
Cleaning the rear Air Intake Grille
x
The air intake grille, at the bottom rear of the
machine, should be cleaned regularly to maintain
optimum drying performance.
x
Remove any obstructions and dust the grille off
with a soft brush .
Warning indicators
x
Warning indicators may differ according to the
model of your dryer.
x
In vented models, pay attention to the placement
of the unit (see installation) and the cleaning of the
vent.
x
Ventilate the room, where the dryer is located, well
during drying.