PAGE
8
OF16
Electrical installation
This appliance must be earthed and the manufacturer
and the seller do not accept responsibility for any
damage due to incorrect installation or electrical
connection.
This appliance should not be connected through an
earth leakage system. Refer to S.A.N.S. 10142
Connection to the power supply
This appliance has a ‘Y’ type supply cord connection
and must be installed by a licensed electrician, who
will ensure that the stove is correctly connected and
safely earthed. The rated current is printed on the
serial number label attached to the stove upper back
panel. The appliance must be connected to the mains
through an All pole isolating switch which has a
minimum clearance between the contacts of 3 mm in
All poles. A means for disconnection must be
provided in the fixed wiring.
The appliance must be installed by a qualified person
in accordance with the regulations in force.
Installation is the buyer’s responsibility. The
manufacturer accepts no liability for this service. Any
action that the manufacturer has to take as a result of
an erroneous installation will not be covered by the
warranty.
3. Installation
Preparation of location and electrical and
gas installation for the appliance is the
customer’s responsibility.
DANGER:
The appliance must be
installed in accordance with all local gas
and/or electrical regulations.
DANGER:
Prior to installation, visually
check if the appliance has any defects on
it. If so, do not have it installed. Damaged
appliances cause risks for your safety.
Do not install the appliance next to
refrigerators or freezers. The heat emitted
by the appliance will lead to an increased
energy consumption of cooling products.
The door and/or handle must not be used
for lifting or moving the appliance.
Do not place any objects onto the
appliance and move it in upright position.
Check the general appearance of your
appliance for any damages that might
have occurred during transportation.
DANGER:
The appliance must be
connected to the mains supply only by
authorised and qualified persons. The
appliances warranty period starts only
after correct installation. The
manufacturer shall not be held
responsible for damages arising from
procedures carried out by unauthorised
persons.
DANGER:
Risk of electric shock, short
circuit or fire by damage of the mains
lead! The mains lead must not be
clamped, bent or trapped or come into
contact with hot parts of the oven. If the
mains lead is damaged, it must be
replaced by a qualified electrician.
DANGER:
Risk of electric shock!
Before starting any work on the electrical
installation, please disconnect the
appliance from the mains supply.
Tips for saving energy
The following information will help you to use your
appliance in an ecological way, and to save energy:
x
Use dark coloured or enamel coated cookware in
the oven since the heat transmission will be better.
x
While cooking your dishes, perform a preheating
operation if it is advised in the user manual or
cooking instructions.
x
Do not open the door of the oven frequently during
cooking.
x
Try to cook more than one dish in the oven at the
same time whenever possible. You can cook by
placing two cooking vessels onto the wire shelf.
x
Cook more than one dish one after another. The
oven will already be hot.
x
You can save energy by switching off your oven a
few minutes before the end of the cooking time. Do
not open the oven door.
x
Defrost frozen dishes before cooking them.
Future Transportation
x
Keep the appliances original carton and transport
the appliance in it. Follow the instructions on the
carton. If you do not have the original carton, pack
the appliance in bubble wrap or thick cardboard
and tape it securely.
Unpacking
x
Please ensure that packaging material is
disposed of in a responsible manner.
x
Plastic bags should be cut up to prevent
children playing with them and accidentally
suffocating.
x
Remove all packing from the oven cavity and
position the accessories.
x
If the appliance is damaged in any way, do not
use it. Report the damage to your dealer, who
will take the necessary corrective action.
Installation
x
Levelling feet are provided to assist you in
positioning your stove so that it will stand firm
and level. To adjust the level, turn the relevant
foot to either raise or lower the stove.
x
Surfaces immediately adjacent to the stove
should be able to withstand temperatures of up
to 100°C without delaminating or discolouring.
