Page 5
UNPACKING
•
Remove all packaging material, accessories and documentation from the dishwasher.
DAMAGE
•
Do not use the dishwasher if it has been damaged in transit. Report the damage to your
dealer, who will take the necessary corrective action.
POSITIONING THE MACHINE
•
The dishwasher should be positioned close to a cold water tap and a drain outlet.
•
After positioning the dishwasher, adjust the feet by turning them in or out to level the unit.
PREPARATION
•
Every dishwasher is tested and run in the factory before being dispatched. Before washing
dishes for the first time, it is advisable therefore to first complete a pre-wash cycle to flush
any factory related residuals from the system.
ELECTRICAL INSTALLATION
•
The dishwasher must be earthed and the manufacturer and seller do not accept
responsibility for any damage due to incorrect electrical connection.
•
.
The machine should be plugged into a 15 Amp, 230 Volt 50 Hz earthed 3 pin wall socket.
•
For safety reasons, the wall socket and the plug should be accessible after installation.
If the power cord should ever need replacing, use only a genuine cord available from the
nearest Defy Service Centre. Repairs should only be made by a qualified technician.
WATER CONNECTION
•
Use a screw on hose connector to secure the filler hose to a 3/4 inch threaded
cold water
tap.
•
The water supply pressure must be between 30 kPa and 1Mpa..
•
If the supply plumbing is new or has not been used for some time, it is advisable to run the water
until it is clear and free from dirt. We recommend fitting a filter to the water tap to prevent
impurities such as sand or rust from entering the washer.
•
Do not use an old hose and only use the hose supplied with the dishwasher.
•
Ensure that the inlet hose is not twisted, bent or squeezed shut.
•
There are two different types of water inlet hoses: Cold water inlet hose (up to 25
°C
) and
hot water inlet hose (up to 60
°C
). Please check which one is applicable to your model.
Before use
4
Installation
5
DRAIN REQUIREMENTS
•
Secure the end of the drain hose to a
drain pipe with an inside diameter of at
least 4cm.
•
The outlet end of the drain pipe should be
between 50cm and 100cm above ground
level.
•
Do not use an old hose and only use the
hose supplied with the dishwasher.
•
Take care not to kink, twist or squeeze the
drain hose.
