Page 15
ON/OFF button (1)
•
Press the On/Off button to switch the
washer on and check that the indicator
light shines.
•
Pressing the On/Off button once more
switches the machine off and the indicator
light dims.
PROGRAMME SELECTION KNOB
Rotate the programme selection knob to the
desired programme. (see programme table in
this book)
START/CANCEL button
•
Press this button to start a selected
programme.
•
The indicator light on the button shines.
•
If you would like to open the door while the
washer is operating, press the button once
more.
•
To restart the programme press the button
again.
PROGRESS INDICATORS
These monitor the washing process
throughout the selected wash cycle and give
a visible indication of progress.
The sequence shows as follows:
HALF LOAD button
(used for partial loads)
•
Press the half load button after selecting a
programme. The indicator light shines.
•
Water and electricity consumption are
reduced.
HOW TO CANCEL A WASHING
PROGRAMME WHILE THE WASHER IS
OPERATING
Press the Start/Stop button for 3 seconds.
The washer will drain the water inside for 45
seconds.
The programme is cancelled when the wash
light switches off.
A new programme may then be selected.
Important
Depending on when the programme was
cancelled, there may be detergent residue or
rinse aid in the washer and on the dish load.
HOW TO CHANGE A WASHING
PROGRAMME WHILE THE WASHER IS
OPERATING
•
Press the Start/Cancel button.
•
The wash light will switch off.
•
Select a new programme.
•
Press the Start/Cancel button.
•
The wash light will switch on.
•
The new programme will start
Important!
The new programme will NOT start from the
beginning but at the stage where the
previous programme was interrupted
.
SALT LEVEL INDICATOR LIGHT
(If applicable)
Please check the indicator regularly. If it
lights up, the salt needs to be replenished.
RINSE AID LEVEL INDICATOR LIGHT
(If applicable)
Please check the indicator regularly. If it
lights up, the Rinse Aid needs to be
replenished.
Description of controls
14
Warning!
At the end of the Washing stage, the
dishwasher will pause for about 35 minutes.
This enables complete drainage of any water
in the machine. This is a normal function and
is no cause for concern.
Warning!
Do not switch the dishwasher off before
the End progress light switches on.
