5 HOMEDEPOT.COM
Please contact 1-866-308-3976 for further assistance.
Installation
1
Determining the mounting
location
NOTE:
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture is
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
□
Determine the mounting location – wall or eave
mount.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
Wall Mount
Eave Mount
2
Removing the mounting plate
NOTE:
This fixture comes with a mounting plate (D). It is
pre-assembled on the light fixture (B) for shipping.
□
Unscrew the two decorative screws (CC)
connecting the light fixture (B) to the mounting
plate (D) and remove the mounting plate (D)
using the pull loop.
Bla
ck
No
ir
Ne
gro
L
N
Wh
ite
Bla
nc
Bla
nco
3
Installing the mounting bracket
WARNING:
Turn the power off at the circuit breaker or
fuse. Place tape over the circuit breaker switch and verify
power is off at the light fixture.
NOTE:
Four mounting bracket screws of various sizes are
included. The installation will only require two. Discard the
unused mounting bracket screws after installation.
□
Remove the existing light fixture.
□
Install the mounting bracket (FF) with the
stamped word “FRONT” facing away from the
junction box. Use the mounting bracket screws
(AA or BB) that best fit the junction box.
□
Firmly pull on the mounting bracket to verify
it is securely mounted to the junction box. If
necessary, use the screws that were removed
from the existing light fixture.
FR
ON
T
FR
ON
T
A
D
B
AA or BB
FF
CC