DSE Model 8620 AMF Controller Operators Manual
105
Schedule Time & Date Selection (1-16)
Press
to begin editing then
or
when
selecting the different parameters in the scheduler.
11.3 ACCESSING THE ‘RUNNING’ CONFIGURATION EDITOR
The ‘running’ editor can be entered while the engine is running. All protections remain active if the
engine is running while the running editor is entered.
Press and hold the
button to enter the running editor.
11.3.1 EDITING A PARAMETER
Enter the editor as described above.
Press the
(left) or
(right) buttons to cycle to the section you wish to
view/change.
Press the
(up or down) buttons to select the parameter you wish to
view/change within the currently selected section.
To edit the parameter, press
to enter edit mode. The parameter begins to flash to
indicate that you are editing the value.
Press the
(up or down) buttons to change the parameter to the required
value.
Press
to save the value. The parameter ceases flashing to indicate that it has
been saved.
To exit the editor at any time, press and hold the
button.
11.3.2 ADJUSTABLE PARAMETERS (RUNNING EDITOR)
Running Editor (Factory default settings are shown in bold italicised text)
Section
Parameter as shown on display
Factory Setting
DISPLAY
Contrast
53%
Language
English
)
Load Demand priority
(1)
Load Power factor
0-100% (0)
Load parallel power
0-100% (50)
Enable commissioning screens
Inactive, Active
Override starting alarms
Inactive, Active
Voltage adjust (manual mode only engine running breaker open)
0-100 % (0)
Frequency adjust (manual mode only engine running breaker open)
0-100 % (0)
Enable mains decoupling test mode (Stop mode only)
Inactive Active
