20
6
System settings
Warning
!
When the “System settings” operating mode is activated, the BlueFox
system
does not
monitor the pool and cannot trigger an alarm. Only
activate the “System settings” operating mode when the pool is being
monitored by another person.
Proceed as follows to carry out system tests or to change system settings:
1. Activate system settings
Press the
button.
If PIN protected: Enter the 4-figure PIN and then press OK (see
page 25
).
Following successful activation the LED alongside the
button will
illuminate permanently.
2. Find the desired function in the table below (system test or system settings)
and then enter the corresponding number combination. When each character
is entered, one of the 4 yellow LEDs will illuminate. To delete the entered char-
acters press the C button.
3. Confirm entry of the number combination with OK.
At this point you will have the following options:
y
Repeat points 2 and 3 to carry out further system settings.
y
Press the
button to quit "System settings". BlueFox will return to the previous
operating mode (e.g. “Active mode”).
Timeout: If no buttons are pressed for 10 seconds, the system will return to the
previous operating mode.
6.1
System tests and system settings
In the following table you will find a list of the possible system tests and all of the
system settings that can be change by the user.
Preparation:
If "System settings" has not yet been activated, then do so (see
Activate system set-
tings, page 20
.
