23
•
3
USE
Saturated carbon filters
The
key flashes (2 short flashes) for
2 minutes after the hood is switched off
to indicate that the carbon filters should
be changed (see the “changing the car-
bon filter” section).
Hold the
key pressed (for at least
5 seconds) to reinitialise the “saturation”
function.
Changing speed
The
function allows your hood to re-
main at maximum speed 4 for
8 minutes and then to switch to speed 2.
After the hood has been started, you can
change the suction speed by pressing on
speed 2 (the
key lights) or
for
speed 3 (the
key lights) for
10 minutes and then speed 2.
Configuring recycling mode
Your hood must be switched off.
By default the hood is in evacuation
mode.
Pressing and holding the
and
keys together (for at least 2 sec) allows
you to switch between Evacuation and
Recycling modes. The
and
keys
light and the
or
keys flash.
A short press on the
key selects re-
cycling mode (the
key flashes and the
key switches off).
A short press on the
key selects
evacuation mode (
key and the
key switches off).
A short press on the
key confirms
the configuration (or automatically
confirmed after 10 seconds).
Time delay / deferred stop
At the end of cooking, you can press the
key to switch off the hood. This func-
tion maintains suction at the selected
speed for 10 minutes; the
key flashes
and power remains on.
To cancel the deferred stop, press the
key again and the deferred stop is can-
celled.
Light
A short press on the
key switches
the light on the hood on and off. With
each long press on the
key, the
brightness is reduced by 25% for each
second the key is held pressed.
Eolysis function
A short press on the
key starts the
function. For 1 hour the hood alternates
between 5 minutes at speed 1 with
10 minutes off; the
key is lit and the
key flashes.
After 1 hour, the hood switches off on its
own. To interrupt this function, press the
key again.
Programming the Eolysis function
A long press on the
key activates
programming.
The
key flashes alternately with the
key, indicating the start of program-
ming.
The number of presses on the
key is
the desired number of program hours
(maximum 9 = 9 hours).
Summary of Contents for Hotte
