Quick Start Guide
EN
Controls Table
A
Rear Left Cooking Zone Selector
B
Front Left Cooking Zone Selector
C
Rear right Cooking Zone Selector
D
Front Right Cooking Zone Selector
E
Power “+” and “-” controls
F
Power pre-set controls
G
Timer “+” and “-” Controls
H
MeMo control
I
Lock control
Quick Start Guide
Prior to using you appliance you need to ensure the appliance has been installed in accordance with the in-
stallation instructions within this guide. Particular attention should be paid to the ventilation requirements
as this could affect the performance of the appliance as well as the long term reliability.
Operation
Care should be taken to ensure that the pan / pans being used cover a minimum of 80% of the cooking
zone.
Place the pan on the zone you wish to use and select the zone on the control panel using the selector con-
trols “A” “B” “C” or “D”.
Select either a pre-set power level “F” or use the “+” or “-” controls “E” to determine the desired power
level. If you wish to control more than one pan these should be selected in turn, noting the controls apply
the power settings to the last zone selected. This is shown by an indicator light adjacent to the zone selec-
tor controls.
You may notice a clicking noise when either using multiple zones or a single zone on low power set-
tings (below level 7). This is normal and should not be considered a fault; it is the electronics of the
appliance regulating the power delivery to the zones. You may notice a corresponding reduction of
the bubbles in the base of the pans on the hob, again this is normal.
Power sharing
The machine is manufactured with the electronics controlling the cooking zones in pairs normally
one pair for the left zones and one for the right zones (left and rear centre, and right and front cen-
tre on the DTI718). The power delivered by the independent electronics is split between these two zones.
If “boost” is selected on one zone the power is reduced on the other to ensure the maximum connected
load is not breached. This is not a fault with the appliance.
From time to time you may wish to select “Boost” on more than one zone; this can be done from selecting
one on the right of the appliance and one on the left.
Suitable cookware
If the display on the appliance flashes when set, this is an indication that either there is no pan on
the zone or, an unsuitable pan is being used. Please refer to the pan guide in the description section
of this guide for further details.
3
