C
hanging the type of gas supply (cont'd)
●
Changing from butane / propane gas
to natural gas
The easy way to install your hob
Cover
Head
Dish
Pan
support
Glass top
Fig. 2
Switch
Fig. 1
Natural
gas
Butane/Propane
gas
50
When carrying out this operation
BEFORE CONNECTING ANYTHING
, you should
successively:
➊
Change the setting on the gas sup-
ply tpe switch.
❷
Adapt the gas connection.
❸
Change the injectors.
➍
Electrical connections
➊
S
WITCH OVER THE GAS CHANGE SWITCH
.
If your home is supplied by butane/propa-
ne gas, you must switch over the gas
change switch located on the front right of
your hob to the mains gas (natural gas)
position
(fig. 1)
.
❷
A
DAPT THE HOB CONNECTION
to the new
gas adjustment. Refer to the
paragraph
“Gas connections”
.
F
OR THE HOB
2
BURNERS
:
❸
C
H A N G E
T H E
I N J E C T O R S
in the
following way:
• Remove the supports, and all the bur-
ner caps and heads.
• Using the wrench provided, unscrew the
injectors located under each crucible and
remove them
(fig. 2)
.
•
Replace these with the injectors
s u p p l i e d i n t h e w a l l e t , i n
accordance with the gas rating table at
the end of the chapter; to do this:
•
Screw in the injectors by hand until
they are tight.
•
P u t t h e s p a n n e r w e l l o n t o t h e
injector.
•
With a pencil draw a line on the
hearth plate as indicated
(fig. 3)
.
•
Turn the spanner clockwise until the
l i n e a p p e a r s o n t h e o t h e r s i d e
(fig. 4)
.
W a r n i n g ! D o n o t g o
beyond this limit as you are liable
to cause damage.
• Put all the burners, covers and pan
supports back in position.
➍
C
ONNECT
the electrical cable from the
hob to your single phase mains supply
(220-240V). Please refer to the
“Electri-
cal connection”
paragraph.
Spanner
Spanner
Line
Line
Fig. 4
Fig. 3
Warning
Screw on the adaptor with a torque not
exceeding 4 N.m.
Exceeding this limit may damage the
product.
