DECKED.COM
|
#DECKEDUSA
|
@DECKEDUSA
MT8 | v.1.1 |
Page 3
▼
ASSEMBLY OVERVIEW
▼
▼
HEY! TORQUE BOY: READ BEFORE YOU INSTALL DECKED
▼
1.
DON'T
over tighten bolts, get em' good 'ole hand-tight.
2.
DON'T
use power tools.
3. If you don't follow directions and do use power tools:
1). Set clutch at a very low setting.
2). Don't blow it.
3). If you blow it, see NOTE.*
NOTE*
Two extra threaded inserts are included in BAG
PREP-EXTRA
. That's all you get.
4).
DON'T
over tighten J-hooks during installation. Make
'em good and snug enough to keep the system from
moving in the bed.
5). Start all bolts with fingers to avoid cross-threading.
NOTE:
In your BAG
PREP-MT6 or MT8
, you will have two
types of 1" length bolts and flanged nuts. One bolt has
a 1/4" diameter, and the other bolt has a 5/16" diameter.
Don't screw this up! The flanged nuts only fit one type
of bolt, so you better at least get that right...
1"
LENGTH
5/16"
DIAMETER
1/4"
DIAMETER
PREP BED:
MARK CENTER OF BED
• Use a marking pen or wax pencil to mark
the center of the bed (blue) on the raised bead.
A
➡
CAB
MAKE SURE MARK SITS AT LEAST
14" HIGH (SO YOU CAN SEE IT)
DETAIL A
