DECKED.COM
|
#DECKEDUSA
|
@DECKEDUSA
MT8 | v.1.1 |
Page 20
FINAL STEPS:
TORSION BRACE + BOTTLE
OPENER
• Slide torsion brace under center vert and tailgate ammo cans.
NOTE:
If you jumped the gun and tightened the J-hooks when installing, loosen them.
• Loosely install:
• Two bolts with nylon washers through the end holes in torsion brace into ammo cans;
BAG
S1.
• Two bolts with nylon washers through the bottom bottle opener holes and torsion brace into center vert;
BAG
S1.
• Two 1/2" length bolts through upper holes in bottle opener into center vert;
BAG
FINAL MID.
• Align bottle opener to edges of center vert and tighten four bottle opener bolts.
• Tighten end bolts into tailgate ammo cans.
• Finally.....Tighten the J-hooks! DO NOT OVER TIGHTEN, just make snug. Make sure the gap between the
sidewall of the bed and the deck is equal on both sides.
TORSION BRACE
BOTTLE OPENER
1/2" LENGTH
BOLTS BAG
FINAL MID
HELPFUL TIP
: Bottle opener goes
outside
of torsion brace.
RECOMMENDED TORQUE:
.905” Bolts - 27 in-lb.
|
J-hooks - 9 in-lb.
1/2” Bolts &
1/4” Ruler screw - 18 in-lb.
