5Network Information
The Network Information parameters define the network names and connection numbers
required for communication between the AS/400 system and the controller. Refer to your
network subscriptions sheets for the required information.
The Network Information Configuration procedure consists of two parts: Network
Information screen and AS/400 System Configuration Parameters.
Define a set of Network Information screens for each of the PUs assigned to the controller.
For example, if the controller was assigned three PUs then three sets of Network
Information and AS/400 System configuration screens will be available. The corresponding
PU number is displayed on the screens.
Define the AS/400 System information screen with the names and connection number
required for the controller to communicate with the host.
The parameters displayed on the screens vary slightly depending on the type of line
assigned to the particular PU.
5.1Network Information Configuration Procedure
Configure the Network Information by defining network parameters that are required for
communication between the Twinax controller and the AS/400 system. Note that some
parameters must be specifically defined for the PUs that were assigned X.25, Token-Ring or
Ethernet attachment line types.
To configure the Network information:
1. Access the Setup menu.
2. Enter option (5) Network Information. The Network Information screen appears.
3. Define the parameters referring to the parameter definitions provided in this chapter.
4. Page forward to access the AS/400 System configuration menus. Define the parameters
for each AS/400 system you want to configure. Each PU can support up to four (4)
AS/400 systems.
5. If you assigned the controller more than one PU, page forward to access the following set
of Network Information configuration menus.
1
Summary of Contents for 3000 Series
Page 1: ...Series 3000 STK3494 3494 User s Manual ...
Page 2: ......
