2
Silicone Sealant
Drill
Level
Rubber Mallet
Pencil
Phillips Screwdriver
Tape Measure
Utility Knife
Important Pre-Installation Information
- Please read this entire instruction book before commencing installation.
- A licenced tradesman must be used for the installation.
- Ensure there is a gasket between all glass and metal components.
- Leave the plastic protectors on the glass corners until the last possible moment
and handle with care.
- Instructions to install the shower tray are included with the shower tray.
- In cold climates, warming the gaskets and seals with hot water or a hairdryer will
assist installation.
- On symmetrical pieces of glass, the E
ZI
Clean coating is only on one face. This
face will have a sticker on it to identify it. This side must be installed on the wet
side of the shower.
Cutting Pliers
6mm (1/4") and
3mm (1/8") Drill Bits
* Use the correct type of drill bit for the material being drilled, with 6mm required for anchor fixing and 3mm used for
screwing directly into the wall studs.
Safety Goggles
Gloves
** As with all toughened glass, take care while handling and wear safety goggles and gloves for personal protection.
Maintenance
- The use of harsh or abrasive cleaners will cause deterioration of the E
ZI
Clean
coating. If water alone is not enough to clean the glass, Decina recommends the
use of mild detergent solutions only.
Tools Required
