Decibel Eleven Switch Doctor, Operation Manuals

Page: 15 / 27

selecting the preset (preset numbers will be displayed as flashing until selected). When
the desired preset number is displayed, it can be selected and loaded by pressing the
middle EDIT switch.
In Split Mode, the middle LED strip is used exclusively to indicate the current status of
the instant access switches on the bottom row. Only the
red LEDs are used. The yellow
control switch LEDs are not used in Split Mode (the control switches are still updated
with the presets, though).
Direct Mode
Direct Mode provides direct instant access to the pedal loop, switch states, and MIDI
continuous controller or note switches (if enabled in setup). To enter Direct Mode from
Preset Mode, press the EDIT switch. This button is used to toggle back and forth
between Preset Mode and Direct Mode, providing the flexibility to quickly make
spontaneous changes.
Direct Mode is arranged by function. There are up to four available instant access
“pages”, depending on what functions have been enabled in SETUP. Direct mode
pages function as follows:
LPS
is a dedicated page for the bypass loops. Pedal bypass loops are toggled on and
off using the bottom row switches 4, 3, 2, 1. The red LEDs above each switch indicate
the state of the loops.
FnS
is used for the control function switches (SW1 and SW2). The bottom row
switches 1&2 control SW1, and switches 3&4 control SW2 (Both switches nearest to
each indicator LEDs are able to be used to control the switches – use either). The
green status LEDs are located above the footswitches.
CC
.
A
or
NT
.
A
(only available if activated in SETUP MODE) is used for instant access
control of the CC.A MIDI Control or NT.A MIDI Note switches. The red LEDs above each
switch indicate the state of the controllers.
CC
.
B
or
NT
.
B
(only available if activated in SETUP MODE) is used for instant access
control of the CC.B MIDI Control or NT.B MIDI Note switches. The red LEDs above each
switch indicate the state of the controllers.
As you toggle back and forth between Preset Mode and Direct mode, the instant
access page will stay where you leave it. This is useful if there is one page that you
want to access most. For example, if you are using Direct Mode to mainly control your
pedal loops, then you can simple leave the page set to
LPS
. If you mostly use Direct
Mode for switching amp channels, then you can select the
FnS
page and it will always
be what you see first when entering Direct Mode. [If you do not need instant access to
13