DEC DECrepeater 90T, Owner'S Manual

Page: 41 / 62

Management 33
Table 4–2 (Cont.) DECbridge 90 Messages
Message Description
No repeater responds Indicates there is no repeater installed in the requested
hub slots, or the repeater is not functioning.
No such port Indicates bridge port number provided to SHOW PORT
was out of the parameter of 1 to 2.
Password too long -
not changed Indicates that a password of more than 16 characters
was given to the DEFINE BRIDGE PASSWORD
command.
Port number
[[hub,]slot,]port Indicates one of the parameters to a SET PORT or
DEFINE PORT command was not a valid hub, slot, or
port number.
Station address
number [first [,last] ]
in range 1-200 Indicates one or more parameters provided to the SHOW
ADDRESS command was out of the range 1 to 200.
??? Indicates that a command or parameter was not
recognized. Type ? to display valid commands.
180501 Appears whenever a loopback diagnostic is run and
passed on the backbone port. If the backbone port is not
receiving any messages, this diagnostic is run every 10
minutes.
180201 Appears whenever a loopback diagnostic is run and
passed on the work group port. If the work group port is
not receiving any messages, this diagnostic is run every
10 minutes.
1805:00-00-00-00
01 Appears whenever a loopback diagnostic is run and fails
on the backbone port. The diagnostic is tried every five
seconds until the test passes.
1802:00-00-00-00
01 Appears whenever a loopback diagnostic is run and fails
on the work group port. The diagnostic is tried every
five seconds until the test passes.
Stand-alone Configuration Management
The recommended process for managing a small stand-alone network is:
• Maintain records indicating which station(s) are connected to each
port on each repeater. It may be desirable to draw a network map.
Digital Internal User Only