DEC AlphaServer 2100, Owner'S Manual

Page: 95 / 192

Verifying System Configuration
show config The
show config
command displays all devices found on the
system bus, PCI bus, and EISA bus. You can use the information
in the display to identify target devices for commands such as
boot
and
test
, as well as to verify that the system sees all the
devices that are installed.
The configuration display shown on the next page includes the
following:
• Core system status:
CPU, memory, and standard I/O are shown with the
results of power-up tests: P (pass) or F (fail)
• Hose 0, Bus 0, 32-bit PCI:
– Slot 0 = Ethernet adapter (ewa0)
– Slot 1 = SCSI controller on standard I/O, along with
storage drives on the bus.
– Slot 2 = EISA to PCI bridge chip
– Slots 3–5 = Reserved
– Slots 6–8 = Correspond to PCI card cage slots: PCI0,
PCI1, and PCI2. In the case of storage controllers, the
devices off the controller are also displayed.
• Hose 1, Bus 0, EISA:
Slot numbers correspond to to EISA card cage slots (1–8).
In the case of storage controllers, the devices off the
controller are also displayed.
• Hose 2, Bus 0, PCI:
Reserved for future expansion.
For more information on device names, refer to the
show device
command in this chapter.
Options and Upgrades 3–11