Dean 1414E, Installation & Operation Manual

Page: 4 / 22

1
1. DESCRIPTION AND
SPECIFICATIONS
The Dean Industries Electric Deep Fat Fryers
are energy-efficient, electrically heated units,
listed by the Underwriter's Laboratory, and
manufactured to the following basic
performance and application specifications. All
units are shipped complete assembled, with any
accessories packed inside the fryer tank. All
units are adjusted, tested and inspected at the
factory prior to crating for shipment.
MODEL 714E 1414E 1818E 2020E
FRYING VESSEL
Frying Area:
Oil Capacity
6-3/4x14
25# 14x 14"
40#
18x18"
70#
20x20
80#
ELECTRICAL
REQUIREMENTS:
Wattage:
Amperage:
18KW
208V, 3hp, 49.9 ALL
MODELS
208V, 1hp, 86.5
240V, 3hp, 45.7
240V, 1hp, 75.0
APPROX. SHIPPING 115# 153# 190# 200#
Note: 1818E and 2020E are also available in 13.5 KW
models.
VESSEL CONSTRUCTION:
Welded, heavy gauge stainless steel; three
heater elements fixed inside the vessel with an
inner chromed wire mesh protective crumb
screen over the elements. Drain tapped into
center of vessel with front-controlled manual
ball valve.
BODY CONSTRUCTION:
Welded steel base, with visible surfaces of
brushed Series 300 stainless steel or painted
steel. Frame supported by 6" adjustable legs or
5" casters on line-ups of multiple units.
OPERATING CONTROLS:
Unit is shipped standard with a liquid bulb filled
thermostat or an optional solid state
temperature controller. Either temperature
control is mounted in the cabinet behind the
front door on or near the cabinet floor. Optional
panel-mounted main power switch, rocker-type
reset switch, melt cycle switch, and instant
power switch are mounted on control panel.
Melt Cycle:
This feature pulses the heating elements on and
off at a controlled rate. This should be used
when the fryer is being used with solid
shortening.
Instant power:
Except on bulb and capillary type thermostats,
this feature
by-passes the temperature
controller for a pre-set period of time to provide
maximum heating power into frying compound
and to allow the operator to anticipate heavy
use.
AUTOMATIC SAFETY FEATURES:
a) High temperature detection to shut off
power to the heating elements should the
controlling thermostat fail.
b) Optional safety switch built into the drain
valve prohibits element operation with the
drain valve even partially open.
RATING PLATE:
This is riveted to the inside right-hand corner of
the fryer door.
Information on this plate includes the model and
serial numbers; when communicating with the
factory about a unit or requesting special parts
or information, this data is essential for proper
identification. Other information on this plate is
the kW output of the heaters and electrical
requirements.
ALL DEAN INDUSTRIES DEEP FAT
FRYERS MUST BE CONNECTED ONLY TO
THE TYPE OF ELECTRICAL SERVICE
IDENTIFIED ON THIS RATING PLATE!