Red Bull Racing RB7: Step by Step
™
16
04
Place the ball end onto the
threaded end of the shaft.
05
Hold the shock shaft with pliers. Screw the ball end onto the shaft (see arrow). Don‘t
fully tighten it yet, as this will aid you in further steps.
01
Take the shock casing and
remove the shock cap. Keep the
cap to one side.
02
Holding the shock casing as
shown, push the shock shaft
into the case until the shaft protrudes
through the hole at the other end of the
casing (see Step 3).
03
Pull the shaft, using some
needle-nose pliers, until it stops
(see arrow). Use pliers with a smooth
inside surface to avoid damaging the
part.
